foto1
foto1
foto1
foto1
foto1

FINAL YEAR PROJECT (FYP) LIST AS FOLLOWS:

  1. Characterization of MEMS structures on piezoelectric materials using KrF excimer laser micromachining
  2. Characterization of MEMS structures on PMMA using KrF excimer laser micromachining
  3.  Characterization of MEMS structures on Silicon wafer using KrF laser micromachining
  4. Characterization of MEMS structures on Indium Tin Oxide (ITO) glass using KrF excimer laser micromachining
  5. Characterization of MEMS structures on SU-8 Photoresist using KrF excimer laser micromachining
  6.   Characterization of MEMS structures on PDMS using KrF excimer laser micromachining
  7. Effect of  anhydrous HF gas-phase etching due to varying temperature
  8. Effect of  anhydrous HF gas-phase etching due to varying pressure
  9.  Effect of  anhydrous HF gas-phase etching due to varying etch time
  10. Effect of  anhydrous HF gas-phase etching due to varying process chemicals
  11.  Deposition of Aluminum oxide on MEMS structures using Electron Beam Evaporator
  12. Deposition of Titanium on MEMS structures using Electron Beam Evaporator
  13.  Deposition of Aluminum on MEMS structures using Electron Beam Evaporator
  14.  Deposition of Nickel on MEMS structures using Electron Beam Evaporator

 

FINAL YEAR PROJECT 2014/2015

  1. Efficient Pattern Detection for Embedded Optical Bio-sensing Systems
  2. FPGA Based System design suitable for Wireless Health Monitoring Employing Intelligent RF module
  3. FPGA Implemention of Contactless Position Sensor Using FSR ( Force Sensor Resistor)
  4. Energy harvesting using FPGA Board
  5. Advanced Printer using FPGA Board
  6. Portable Printer using FPGA Board
  7. FPGA Implementation of a low-cost method for tracking the resonance frequency and the quality factor of MEMS sensors
  8. Fabricant of Arrayed Microneedle Using Laser Micromachine Process
  9. Fabricant of Arrayed Microcantilever using Laser Micromachine Process
  10. Low temperature deposition of Si3N4 using plasma enchanced chemical vapor deposition (PECVD)
  11. Development a tool and process for substrate thining using TMAH and KOH
  12. Setting of advance anhyrous HF gas-phase etching in difference pressure
  13. Thin film of Pt coatings using Electron Beam Vapor
  14. Physical deformation in the laser-machined sites on PDMS
  15. Physical deformation in the laser-machined on SU-8 photoresist
  16. Physical deformation in the laser-machined sites on Teflon
  17. A microfabricated rotary pump using laser micromachining
  18. Surface properties modification using melecular vapour deposition for biosensor application

 

FINAL YEAR PROJECT 2015/2016

  1. DE2 115 Based Automated Poultry Processing Tool
  2. Process development and characterization towards microstructural realization using laser micromachining for MEMS
  3. Process development and characterization towards piezoelectric nanofilm for NEMS/MEMS
  4. Process development and characterization towards hydrophobic nanolever realization for NEMS/MEMS

 

 


Privacy Policy

Security Policy

Disclaimer

Copyright

Advanced Multidisciplinary MEMS-Based Integrated Electronic NCER Centre of Excellence (AMBIENCE)
School of Microelectronic Engineering,
Universiti Malaysia Perlis (UniMAP),
SME Bank Industrial Estate, 02000 Kuala Perlis,
Perlis.

Tel: +604-9854724